fruled Command

The fruled command blinks hardware attention indicators (LEDs) or turns them off.

This command can control the cell attention LEDs in all cell-based servers, as well as the I/O chassis LEDs on Superdome servers. The fruled command also can start and stop blinking the cabinet number LCDs on HP Superdome compute cabinets and I/O expansion cabinets.

Refer to the fruled(1) manpage for details.

Synopsis

fruled [-f|-o] [-B] -c cell [-c...] 
fruled [-f|-o] [-B] -i IOchassis [-i...] 
fruled [-f|-o] -b cabinet [-b...] 
fruled [-f] -C [-l cabinet] [-l...] 
fruled [-f] -I [-l cabinet] [-l...]

Enhanced nPartition Commands Notes.

The -u... -h... set of options may be specified to cause the command to send its management request using WBEM to an nPartition other than the local nPartition (but can also be used as a "loopback access" to the local nPartition).
The -g... -h... options may be specified to cause the command to send its management request using IPMI over LAN to a service processor in another server complex (but can also be used as a "loopback access" to the service processor in the local complex).

The -u and -g options are mutually exclusive.

Options

-f

Turn off specified attention LED(s). This is the default.

The -f and -o options are mutually exclusive.

-o

Start blinking the specified attention LED(s). The -o option is unavailable with -C or -I.

-B

Start or stop blinking the cabinet number LCD of the cabinet that contains the cell or I/O chassis.

The -B option is only available with -c and -i.

-c cell

Blink or turn off the specified cell attention LED.

cell can be specified either in the local (cabinet/slot) or global (cell_ID) format.

-i IOchassis

Blink or turn off the specified IOchassis attention LED.

-b cabinet

Start or stop blinking the cabinet number LCD of the specified cabinet.

-C

Turn off all cell attention LEDs.

-l cabinet

Limit the scope of the -C or -I option to a given cabinet.

-u username

Enhanced nPartition Commands only. Specifies the account and authorization to access an nPartition other than the local nPartition.

The -h option is required if this option is used.

username specifies a configured user name on the target nPartition.

-g

Enhanced nPartition Commands only. Allows access to the complex specified by the -h option. The accessed complex is then considered the target complex. Access is through the service processor LAN port.The -h option is required if this option is used.

-h IPaddress|hostname

Enhanced nPartition Commands only. This option is only used in combination with either the -u or -g option. IPaddress|hostname specifies the IP address or hostname of the target nPartition (-u) or service processor (-g).

fruled Command

Technical documentation

» Table of Contents

Synopsis

Options