This chapter describes setting up an Ignite-UX server to cold install HP-UX 11i v1, v2, and v3
on clients over the network. You must have
superuser privileges to set up an Ignite-UX server. You can stop anywhere in this procedure and resume where you left
off at a later time.
This document assumes the network boot clients are on the same subnet as the Ignite-UX
server. This document also assumes the network DHCP and DNS servers
are already set up. These network services are vital to Ignite-UX
server operation. If the Ignite-UX server is intended to support these
network functions on an isolated subnet, the user should consult documentation
that indicates how to set them up. Network services should be set
up before the Ignite-UX server is set up. See http://www.docs.hp.com for networking documentation.
Printable version
