Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
HP-UX Reference > T

t_rcvdis(3)

HP-UX 11i Version 3: February 2007
» 

Technical documentation

» Feedback
Content starts here

 » Table of Contents

 » Index

NAME

t_rcvdis() — retrieve information from disconnect

SYNOPSIS

#include <xti.h> /* for X/OPEN Transport Interface - XTI */ /* or */ #include <tiuser.h> /* for Transport Layer Interface - TLI */ int t_rcvdis (fd, discon); int fd; struct t_discon *discon;

DESCRIPTION

The t_rcvdis() function is used to identify the cause of a disconnect, and to retrieve any user data sent with the disconnect. fd identifies the local transport endpoint where the connection existed. discon points to a t_discon structure containing the following members:

struct netbuf udata; int reason; int sequence;

The type netbuf structure is defined in the <xti.h> or <tiuser.h> header file. This structure, which is used to define buffer parameters, has the following members:

unsigned int maxlen

maximum byte length of the data buffer

unsigned int len

actual byte length of data written to buffer

char *buf

points to buffer location

reason specifies the reason for the disconnect through a protocol-dependent reason code. For HP XTI over the OSI transport provider, these codes are described in the OTS/9000 manual section under "Transport Errors". For TLI, see the documentation for the transport provider being used. udata identifies any user data that was sent with the disconnect. sequence may identify an outstanding connect indication with which the disconnect is associated. sequence is only meaningful when t_rcvdis() is issued by a passive transport user who has executed one or more t_listen() functions and is processing the resulting connect indications. If a disconnect indication occurs, sequence can be used to identify which of the outstanding connect indications is associated with the disconnect.

If a user does not care that there is incoming data and does not need to know the value of reason or sequence, discon may be a null pointer and any user data associated with the disconnect will be discarded. However, if a user has retrieved more than one outstanding connect indication (via t_listen()) and discon is a null pointer, the user will be unable to identify with which connect indication the disconnect is associated.

Valid States

T_DATAXFER, T_OUTCON, T_OUTREL, T_INREL, T_INCON (ocnt > 0)

Fork Safety

t_rcvdis is not fork-safe.

RETURN VALUE

Upon successful completion, a value of 0 is returned. Otherwise, a value of -1 is returned and t_errno is set to indicate the error.

ERRORS

On failure, t_errno is set to one of the following:

[TBADF]

The specified identifier does not refer to a transport endpoint.

[TNODIS]

No disconnect indication currently exists on the specified transport endpoint.

[TBUFOVFLW]

The number of bytes allocated for incoming data is not sufficient to store the data. If fd is a passive endpoint with ocnt (number of outstanding connections) > 1, it remains in state T_INCON (see t_getstate). Otherwise, the endpoint state is set to T_IDLE.

[TNOTSUPPORT]

This function is not supported by the underlying transport provider.

[TOUTSTATE]

(XTI only) This function was issued in the wrong sequence on the transport endpoint referenced by fd.

[TSYSERR]

A system error has occurred during execution of this function.

[TPROTO]

(XTI only) This error indicates that a communication problem has been detected between XTI and the transport provider for which there is no existing XTI (t_errno).

STANDARDS CONFORMANCE

t_rcvdis(): SVID2, XPG3, XPG4

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 1983-2007 Hewlett-Packard Development Company, L.P.