Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
HP-UX Virtual Partitions Administrator’s Guide > Chapter 4 Installing, Updating, or Removing vPars and Upgrading Servers with vPars

Updating from vPars A.03.xx to A.05.xx

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

At the time of this publication, updating directly from vPars A.03.xx to A.05.xx is not supported because the Update-UX tool does not support updating directly from 11i v1 (11.11) to 11i v3 (11.31). However, as a general workaround, you can attempt the following process. However, there are many differences not only between vPars A.03.xx and A.05.xx, but also between 11.11 and 11.31. Be sure to read the applicable release notes for your given hardware (server, cards, and expansion units), operating system, and vPars software. If you need help, contact your HP Support Representative.

Note that there is no update software process to move from PA to Integrity servers.

General Process for A.03.xx to A.05.xx Workaround (PA only)

The general process for updating from A.03.xx to A.05.xx is to perform the update in two steps:

  1. Update your virtual partitions from A.03.xx to A.04.02 or later.

    “Updating from vPars A.03.xx to A.04.xx”

  2. Update your virtual partitions from A.04.02 or later to A.05.01

    “Updating from vPars A.04.xx to A.05.xx”

    “Updating from vPars A.04.xx to Mixed HP-UX 11i v2/v3 vPars (A.04.xx and A.05.xx) Environment”

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2008 Hewlett-Packard Development Company, L.P.