Jump to content United States-English
HP.com Home Products and Services Support and Drivers Solutions How to Buy
» Contact HP
More options
HP.com home
HP-UX Virtual Partitions Administrator’s Guide > Chapter 6 CPU, Memory, and I/O Resources (A.05.xx)

CPU: Notes on vPars Syntax, Rules, and Output

» 

Technical documentation

Complete book in PDF
» Feedback
Content starts here

 » Table of Contents

 » Glossary

 » Index

CPU: CLI Rules for Dynamic Migration of Memory and CPU

Note the following CLI (Command Line Interface) rules for online migration of memory and CPUs while the target partitions are up. Note that because the following applies to only online migration (in other words, where the target partition is up), the following does not apply to the vparcreate command, where the target virtual partition should never be up during the vparcreate invocation.

  • In the same command, you cannot have an online addition and online deletion. For example, the following are illegal:

    • keira1# vparmodify -p keira2 -a cpu::2 -d cpu::1

    • keira1# vparmodify -p keira2 -a mem::1024 -d mem::512

    You must specify each change on a separate command line. For example, the following are allowed:

    • keira1# vparmodify -p keira2 -a cpu::2 keira1# vparmodify -p keira2 -d cpu::1
    • keira1# vparmodify -p keira2 -a mem::1024 keira1# vparmodify -p keira2 -d mem::512
  • In the same command, you cannot make changes to both memory and CPU. For example, the following are illegal:

    • keira1# vparmodify -p keira2 -a cpu::2 -a mem::1024

CPU: Deleting CPUs Summary

  • The current boot processor can not be deleted from a virtual partition. (Use vparstatus -v to determine the current boot processor.) If you wish to delete a specific CPU that is being used as a boot processor by a booted virtual partition, you will need to shutdown the virtual partition and then delete the desired CPU.

CPU: vparstatus

  • When a virtual partition is down, the CPUs assigned to that partition are reserved to that partition and cannot be used for other partitions. For example, vparstatus does not show any CPU assigned as the boot processor. The boot processor is not assigned until the virtual partition is actually booted.

  • If a virtual partition is down and assigned only one CPU, a CPU will be reserved by the vPars Monitor, making it unavailable. The specific CPU reserved is not determined until boot time. As a result, while the virtual partition is down, vparstatus -A, which shows available resources, will show all the possible paths of unassigned CPUs but the count of available CPUs will be one less. The count reflects the actual number of available CPUs because one CPU is reserved for the down virtual partition.

CPU: Counts Summary

  • At all times, the rule of min<=total<=max is enforced.

  • When adding by CLP, the total count changes whether the partition is up or down.

  • When adding by hardware path, the total count changes only when the partition is up. The total does not change if the specified CPU is already assigned to the partition.

  • When adding by hardware path and the partition is down, you cannot have the number of CPUs added by hardware path exceed the current total value.

Printable version
Privacy statement Using this site means you accept its terms Feedback to webmaster
© 2008 Hewlett-Packard Development Company, L.P.